Ads
related to: metric splined shaft stock
Search results
Results from the WOW.Com Content Network
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found use in vehicles like the TrailBlazer SS, Saab 9-7X, and SSR.
35 Spline axle shafts with a 1.5 in (38 mm) diameter; ... The new axle also came with disc brakes and a unique 8x170 mm (6.7 in) metric lug pattern. Options and ...
THM400 units had a 32 spline output shaft. A variant known as a THM375 is a THM400 built to mate to the smaller driveshaft yokes typically used for THM350 applications. They used a Chevrolet bolt-pattern case with a longer 27 spline output shaft inside a matching tailhousing cast with a "375-THM" or "TH375" identifier.
The benefit is the larger ring gear, better angle cut on the teeth and Dana 60 diameter pinion shaft. The Dana Spicer Max momentary output torque FT-lbs Low pinion Dana 44 30 spline.....3460 [ft-lbs] High pinion Dana 44 30 spline.....4170 [ft-lbs] Low pinion rear 8.9" Dana 44 32 spline..5340 [ft-lbs]
Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.
A split shaft PTO is mounted to the truck's drive shaft to provide power to the PTO. Such a unit is an additional gearbox that separates the vehicle's drive shaft into two parts: The gearbox-facing shaft which will transmit the power of the engine to the split shaft PTO; The axle-facing shaft which transmit the propelling power to the axle.
The spline drive was part of the obsolete, U.S-designed Optimum Metric Fastener System and was defined by ASTM B18.2.7.1M, which was withdrawn in 2011, [85] making the spline drive obsolescent. Spline drives were specified for 5, 6.3, 8, 10, 12, 14, 16, and 20 mm size screws. [ 86 ]
Ads
related to: metric splined shaft stock