enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.

3. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

4. List of valves - Wikipedia

   en.wikipedia.org/wiki/List_of_valves

   Butterfly valve, for on–off flow control in large diameter pipes; Choke valve, a solid cylinder placed around or inside a second cylinder with multiple holes or ...

5. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   As with other flared connection systems, the seal is achieved through metal-to-metal contact between the finished surface of the fitting nose and the inside diameter of the flared tubing. The sleeve is used to evenly distribute the compressive forces of the flare nut to the flared end of the tube.

6. Schrader valve - Wikipedia

   en.wikipedia.org/wiki/Schrader_valve

   The Schrader valve consists of a valve stem into which a valve core is threaded. The valve core is a poppet valve assisted by a spring. A small rubber seal located on the core keeps the fluid from escaping through the threads. Using the appropriate tools, a faulty valve core can be immediately extracted from the valve stem and replaced with a ...

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Valves are available in several types, based on design and purpose: Gate, plug, or ball valves – Isolation; Globe valve – Throttling; Needle valve – Throttling, usually with high precision but low flow; Butterfly or diaphragm valves – Isolation and throttling; Check valve – Preventing reverse flow (non-return)