Search results
Results from the WOW.Com Content Network
EN 10027-1 steel grade designation system. European standard steel grade names fall into two categories: [1] Steel specified by purpose of use and mechanical properties. Steel specified by chemical composition. The inclusion of a letter 'G' before the code indicates the steel is specified in the form of a casting.
Maraging steels are usually described by a number (e.g., SAE steel grades 200, 250, 300 or 350), which indicates the approximate nominal tensile strength in thousands of pounds per square inch (ksi); the compositions and required properties are defined in US military standard MIL-S-46850D. [8]
ASTM A992 steel is a structural steel alloy often used in the US for steel wide-flange and I beams. Like other carbon steels, the density of ASTM A992 steel is approximately 7850 kg/m 3 (0.2836 lb/in 3 ). ASTM A992 steel has the following minimum mechanical properties, according to ASTM specification A992/A992M.
Ultimate tensile strength (also called UTS, tensile strength, TS, ultimate strength or in notation) [ 1] is the maximum stress that a material can withstand while being stretched or pulled before breaking. In brittle materials, the ultimate tensile strength is close to the yield point, whereas in ductile materials, the ultimate tensile strength ...
The NLGI consistency number or NLGI grade expresses a measure of the relative hardness of a grease used for lubrication, as specified by the standard classification of lubricating grease established by the National Lubricating Grease Institute (NLGI). Reproduced in standards ASTM D4950 (“standard classification and specification of automotive ...
Abrasion resistant steel is typically used in applications requiring high wear resistance, including backhoe buckets and teeth, bulldozer blades, dump truck beds, ore and coal chutes, augers and aggregate conveyors. [ 6] Additional uses include shooting targets and armor, AR500 steel is commonly used for these applications as higher BHN steels ...
When converting oil density to specific gravity using the above definition, it is important to use the correct density of water, according to the standard conditions used when the measurement was made. The official density of water at 60 °F according to the 2008 edition of ASTM D1250 is 999.016 kg/m 3. [2] The 1980 value is 999.012 kg/m 3. [3]
The Melt Flow Index ( MFI) is a measure of the ease of flow of the melt of a thermoplastic polymer. It is defined as the mass of polymer, in grams, flowing in ten minutes through a capillary of a specific diameter and length by a pressure applied via prescribed alternative gravimetric weights for alternative prescribed temperatures. [ 1][ 2 ...