Search results
Results from the WOW.Com Content Network
Superheating. In thermodynamics, superheating (sometimes referred to as boiling retardation, or boiling delay) is the phenomenon in which a liquid is heated to a temperature higher than its boiling point, without boiling. This is a so-called metastable state or metastate, where boiling might occur at any time, induced by external or internal ...
Superheated water is liquid water under pressure at temperatures between the usual boiling point, 100 °C (212 °F) and the critical temperature, 374 °C (705 °F). [citation needed] It is also known as "subcritical water" or "pressurized hot water". Superheated water is stable because of overpressure that raises the boiling point, or by ...
By this definition, a saturated liquid has q = 0. A saturated vapor has q = 1. [3] An alternative definition is the 'equilibrium thermodynamic quality'. It can be used only for single-component mixtures (e.g. water with steam), and can take values < 0 (for sub-cooled fluids) and > 1 (for super-heated vapors):
Superheated steam was widely used in main line steam locomotives. Saturated steam has three main disadvantages in a steam engine: it contains small droplets of water which have to be periodically drained from the cylinders; being precisely at the boiling point of water for the boiler pressure in use, it inevitably condenses to some extent in the steam pipes and cylinders outside the boiler ...
An enthalpy–entropy chart, also known as the H–S chart or Mollier diagram, plots the total heat against entropy, [1] describing the enthalpy of a thermodynamic system. [2] A typical chart covers a pressure range of 0.01–1000 bar, and temperatures up to 800 degrees Celsius. [3] It shows enthalpy in terms of internal energy , pressure and ...
Steam. Steam is a substance containing water in the gas phase, often mixed with air and/or an aerosol of liquid water droplets. This may occur due to evaporation or due to boiling, where heat is applied until water reaches the enthalpy of vaporization.
The Rankine cycle is an idealized thermodynamic cycle describing the process by which certain heat engines, such as steam turbines or reciprocating steam engines, allow mechanical work to be extracted from a fluid as it moves between a heat source and heat sink. The Rankine cycle is named after William John Macquorn Rankine, a Scottish polymath ...
Saturation vapor curve. In thermodynamics, the saturation vapor curve is the curve separating the two- phase state and the superheated vapor state in the T–s diagram ( temperature–entropy diagram ). The saturated liquid curve is the curve separating the subcooled liquid state and the two-phase state in the T–s diagram.