enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

4. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   Many public organizations maintain hose clamp standards, such as Aerospace Industries Association's National Aerospace Standards NAS1922 and NAS1924, the Society of Automotive Engineers' J1508, etc. [3] [4] Pairs of screw clamps on a short rubber tube form a "no-hub band," often used for attaching sections of domestic wastewater piping, or used ...

5. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...

6. Riser clamp - Wikipedia

   en.wikipedia.org/wiki/Riser_clamp

   A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them onto the pipe.

7. EIA RF Connectors - Wikipedia

   en.wikipedia.org/wiki/EIA_RF_Connectors

   EIA RF Connectors are used to connect two items of high power radio ... Sizes covered under these two standards range from 3/8 to 6 1/8 inch outside diameter (OD) for ...

8. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]

9. Cable tray - Wikipedia

   en.wikipedia.org/wiki/Cable_tray

   To maintain support of cables at changes of elevation or direction of a tray, a large number of specialized cable tray fittings are made compatible with each style and manufacturer. Horizontal elbows change direction of a tray in the same plane as the bottom of the tray and are made in 30, 45 and 90 degree forms; inside and outside elbows are ...