enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Offenhauser - Wikipedia

   en.wikipedia.org/wiki/Offenhauser

   An Offenhauser midget engine, polished for display Offenhauser midget car engine - front view. Offenhauser produced engine blocks in several sizes. These blocks could be bored out or sleeved to vary the cylinder bore, and could be used with crankshafts of various strokes, resulting in a wide variety of engine displacements.

3. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   The hydraulic cylinders on this excavator operate the machine's linkages. Hydraulic cylinders in a hot press of a particle board machine. A hydraulic cylinder (also called a linear hydraulic motor) is a mechanical actuator that is used to give a unidirectional force through a unidirectional stroke.

4. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The hydraulic pressure created by moving a piston (inside the bore of the master cylinder) toward the slave cylinder(s) compresses the fluid evenly, but by varying the comparative surface area of the master cylinder and each slave cylinder, one can vary the amount of force and displacement applied to each slave cylinder, relative to the amount ...

5. Sleeve valve - Wikipedia

   en.wikipedia.org/wiki/Sleeve_valve

   A sleeve valve takes the form of one (or in the case of double sleeve valves, two) machined cylinders which fit concentrically between the piston and the cylinder block bore of an internal combustion engine having cross-flow induction/exhaust. These sleeves have inlet and exhaust ports machined in the periphery, analogous to a two-stroke motor ...

6. Boring (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Boring_(manufacturing)

   A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.

7. Hydraulic diameter - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_diameter

   The hydraulic diameter, D H, is a commonly used term when handling flow in non-circular tubes and channels. Using this term, one can calculate many things in the same way as for a round tube. Using this term, one can calculate many things in the same way as for a round tube.