Search results
Results from the WOW.Com Content Network
A tack cloth made of gauze impregnated with a tacky material. Tack cloth (tack rag; tac cloth) is a specialized type of wiping cloth that is treated with a tacky material. It is designed to remove loose particles of dust, dirt and lint that would contaminate a surface that is to be painted, coated, laminated, photo-etched, or otherwise finished.
Pipe clamps being used to glue up a wooden lamination. A common use of pipe clamps in woodworking is for edge gluing; several boards being joined edge to edge to produce a wider surface such as a table top or cabinet components. In this case several pipe clamps will be set up on the workbench so that clamping pressure can be applied evenly ...
Wooden barrels made of multiple staves. A wood stave pipeline for a hydropower application. Wood stave pipeline part of the Yakima Project. A stave is a narrow length of wood with a slightly bevelled edge to form the sides of barrels, tanks, tubs, vats and pipelines, originally handmade by coopers. [1]
Tack strip being removed from a floor. Tack strip also known as gripper rod, carpet gripper, Smoothedge tackless strip, gripper strip or gripper edge is a thin piece of wood, between 1 and 2 metres (3.3 and 6.6 ft) long and about 3 centimetres (1.2 in) wide, studded with hundreds of sharp nails or tacks used in the installation of carpet.
A grommet is a ring or edge strip inserted into a hole through thin material, typically a sheet of textile fabric, sheet metal or composite of carbon fiber, wood or honeycomb. Grommets are generally flared or collared on each side to keep them in place, and are often made of metal, plastic, or rubber. They may be used to prevent tearing or ...
Normally, the desired outcome of jointing is an edge which is straight along its length and perpendicular to the face of the board. However, there is another technique often used when gluing up panels, referred to as a sprung joint. [1] In this technique, the desired outcome is an edge which is slightly concave along its length.
Soft jaws are made of soft materials such as soft (unhardened) metal, plastic, or wood. They can be machined as needed for particular setups. The typical interface between the master jaw and the removable jaw is a matching pair of serrated surfaces, which, once clamped by the mounting screws, cannot allow relative slipping between the two parts.
The bevel provides a smooth clean edge to the plate or pipe and allows a weld of the correct shape (to prevent center-line cracking) to join the separate pieces of metal. [citation needed] Simple bevels can be used with a backup strip (thin removable sheet behind the plate joint) with chamfers (and a small land) being used on open root welds.