Search results
Results from the WOW.Com Content Network
Nik Semenoff has developed a palm press that serves as a baren replacement, made with a number of roller bearings alternating on two close spaced shafts in a small hand held mounting. The bearings have negligible friction and the pressures achievable are suitable for some offset lithography printing, though wider spacing of fewer contact points ...
A cutting mat is a mat that is placed between a workpiece to be cut and the surface below (e.g. a table) to protect the surface. They are used, amongst other things, in hobby work for precise and clean cuts of paper, cardboard or textiles using a scalpel or rotary cutter .
A single-cut file has one set of parallel teeth while a cross-cut or double-cut file has a second set of cuts forming diamond shaped cutting surfaces. [1] In Swiss-pattern files the teeth are cut at a shallower angle, and are graded by number, with a number 1 file being coarser than a number 2, etc.
The completed mask with opened exposure windows is then placed atop a photo-sensitive printing plate, which both plate and mask with stripped negatives fixed by register pins, and then vacuum-sealed in a framed enclosure under glass and exposed to very bright light, allowing the rays to pass through the negatives and expose the printing plate's ...
Rotary die cutting is die cutting using a cylindrical die on a rotary press and may be known as a rotary die cutter or RDC. A long sheet or web of material will be fed through the press into an area known as a "station" which holds a rotary tool that will cut out shapes, make perforations or creases, or even cut the sheet or web into smaller parts.
In intaglio printing, the lines to be printed are cut into a metal (e.g. copper) plate by means either of a cutting tool called a burin, held in the hand – in which case the process is called engraving; or through the corrosive action of acid – in which case the process is known as etching.
Other terms often used for printed engravings are copper engraving, copper-plate engraving or line engraving. Steel engraving is the same technique, on steel or steel-faced plates, and was mostly used for banknotes, illustrations for books, magazines and reproductive prints, letterheads and similar uses from about 1790 to the early 20th century, when the technique became less popular, except ...
Moving the handle pushes the head straight through the sheets of paper. The hard edge of the punch vs the die cuts a hole in the paper, pushing the cut piece out the bottom of the die. The cut-out bit of paper scrap is called a chad. The handle functions as a lever, decreasing the amount of force the operator needs to apply.