Search results
Results from the WOW.Com Content Network
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
current: 01:17, 9 January 2007: ... Schematic diagram of optocoupler. Own work. 00:05, 9 January 2007: 320 × 240 (7 KB) Riflemann~commonswiki: Optocoupler schematic ...
English: A diagram of a simple circuit using an optocoupler. When the switch S' 1 is closed, the diode emits light and the transistor conducts. v' out thus goes low. This circuit therefore acts much like a logicalNOT gate.
It breaks down a system into units, and then any number of sub-assemblies. The unit is the highest level of demarcation in a system and is always a numeral. Subsequent demarcation are called assemblies and always have the Class Letter "A" as a prefix following by a sequential number starting with 1.
IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [ a ] ICs have at least two pins that connect to the power rails of the circuit in which they are installed.
Typical use of TL431 in SMPS. Shunt resistor R3 maintains minimum TL431 current, series resistor R4 is part of frequency compensation network (C1R4) [31] [32] In the 21st century, the TL431, loaded with an optocoupler's light-emitting diode (LED), is the de facto industry standard solution for regulated switched-mode power supplies (SMPS).
Parts in this section have a pin count of 14 pins or more. The lower part numbers were established in the 1960s and 1970s, then higher part numbers were added incrementally over decades. IC manufacturers continue to make a core subset of this group, but many of these part numbers are considered obsolete and no longer manufactured.
A small outline integrated circuit (SOIC) is a surface-mounted integrated circuit (IC) package which occupies an area about 30–50% less than an equivalent dual in-line package (DIP), with a typical thickness being 70% less. They are generally available in the same pin-outs as their counterpart DIP ICs.