Search results
Results from the WOW.Com Content Network
Control of resistive loads and solid state loads with opto-coupler isolation: 60947-5-1 60947-5-2 DC-13: Control of D.C. electromagnetics: 60947-5-1 60947-5-2 DC-14: Control of D.C. electromagnetic loads having economy resistors in the circuit: 60947-5-1 DC-20: Connecting and disconnecting under no-load conditions: 60947-5-1 DC-21
IP65 touchscreen display IP65 LED lamp. The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical enclosures against ...
Prior to the STC rating, the sound isolation performance of a partition was measured and reported as the average transmission loss of over the frequency range 128 to 4096 Hz or 256 to 1021 Hz. [ 8 ] [ 9 ] This method is valuable at comparing homogeneous partitions that follow the mass law, but can be misleading when comparing complex or multi ...
Most insulated wire and cable products have maximum ratings for voltage and conductor temperature. The product may not have an ampacity (current-carrying capacity) rating, since this is dependent on the surrounding environment (e.g. ambient temperature). In electronic systems, printed circuit boards are made from epoxy plastic and fibreglass ...
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
The network isolator is a passive device, and functions without any requirement of an external power supply. A functional equivalent to network isolators is Ethernet over a small stretch of optical fibre, using media converters or Ethernet switches/network cards with fiber connections on each end.
The electrical insulation system for wires used in generators, electric motors, transformers, and other wire-wound electrical components is divided into different classes by temperature and temperature rise.
The Comparative Tracking Index (CTI) is used to measure the electrical breakdown (tracking) properties of an insulating material.Tracking is an electrical breakdown on the surface of an insulating material wherein an initial exposure to electrical arcing heat carbonizes the material.