Ads
related to: belt drive versus direct turntable lift unit with electric
Search results
Results from the WOW.Com Content Network
The functional relationship between the drive belt, sub-platter, and motor pulley, can be seen through the glass platter on a Rega Planar 3.. There are three main types of phonograph turntable drives being manufactured today: the belt-drive, idler-wheel and direct-drive systems; the names are based upon the type of coupling used between the platter of the turntable and the motor.
In a direct-drive turntable the motor is located directly under the center of the platter and is connected to the platter directly. It is a significant advancement over older belt-drive turntables for turntablism, since they have a slower start-up time and torque, and are prone to wear-and-tear and breakage, [5] as the belt would break from backspinning or scratching. [6]
Early belt-drive turntables were unsuitable for turntablism, since they had a slow start-up time, and they were prone to wear-and-tear and breakage, [9] as the belt would break from backspinning or scratching. [10] The first direct-drive turntable was invented by Shuichi Obata, an engineer at Matsushita (now Panasonic), [11] based in Osaka ...
There are presently three main phonograph designs: belt-drive, direct-drive, and idler-wheel. In a belt-drive turntable the motor is located off-center from the platter, either underneath it or entirely outside of it, and is connected to the platter or counter-platter by a drive belt made from elastomeric material. The direct-drive turntable ...
The drive system designed by Matsushita is direct-drive rather than the more commonly found belt-drive type, a less expensive design. The direct-drive design, which was developed to reduce wow and flutter, produces a very quiet turntable that, for a direct-drive turntable, has minimal motor and bearing noise, (although the bearing rumble does ...
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...
Sign in to your AOL account.
Four wool spinning machines driven by belts from an overhead lineshaft (Leipzig, Germany, circa 1925) The belt drives of the Mueller Mill, model and reality, in motionA line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century.
Ads
related to: belt drive versus direct turntable lift unit with electric