Search results
Results from the WOW.Com Content Network
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
One of the issues with using an RC network to generate a PoR pulse is the sensitivity of the R and C values to the power-supply ramp characteristics. When the power supply ramp is rapid, the R and C values can be calculated so that the time to reach the switching threshold of the Schmitt trigger is enough to apply a long enough reset pulse.
Power cycling is the act of turning a piece of equipment, usually a computer, off and then on again.Reasons for power cycling include having an electronic device reinitialize its set of configuration parameters or recover from an unresponsive state of its mission critical functionality, such as in a crash or hang situation.
Power supply may be bad Long continuous beep tone Memory failure Steady, long beeps Power supply bad No beep Power supply bad, system not plugged in, or power not turned on No beep If everything seems to be functioning correctly there may be a problem with the 'beeper' itself. The system will normally beep one short beep. One long, two short beeps
This is an accepted version of this page This is the latest accepted revision, reviewed on 2 December 2024. Restoring the software of an electronic device to its original state For the Tilian Pearson album, see Factory Reset (album). A factory reset, also known as hard reset or master reset, is a software restore of an electronic device to its original system state by erasing all data ...
Most desktop personal computer power supplies are a square metal box, and have a large bundle of wires emerging from one end. Opposite the wire bundle is the back face of the power supply, with an air vent and an IEC 60320 C14 connector to supply AC power. There may be a power switch and/or a voltage selector switch.
An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.