Ad
related to: bad vapor canister purge valve symptoms causesebay.com has been visited by 1M+ users in the past month
- Gift Cards
eBay Gift Cards to the Rescue.
Give The Gift You Know They’ll Love
- Home & Garden
From Generators to Rugs to Bedding.
You’ll Find Everything You Need
- Trending on eBay
Inspired by Trending Stories.
Find Out What's Hot and New on eBay
- Under $10
Fun Stuff. Ships Free.
Brand New. Guilt Free.
- Gift Cards
Search results
Results from the WOW.Com Content Network
An onboard refueling vapor recovery system (ORVR) is a vehicle fuel vapor emission control system that captures volatile organic compounds (VOC, potentially harmful vapors) during refueling. [ 1 ] [ page needed ] There are two types of vehicle fuel vapor emission control systems: the ORVR, and the Stage II vapor recovery system. [ 2 ]
The intake manifold vacuum, with wide open throttle, is lower in these conditions, which causes the PCV valve to open and the crankcase gases flow to the intake system. [13] The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the ...
Otherwise, air lock may cause waterfall flow where the loss of hydraulic head is equal to the height of airlock; If the hydraulic grade line drops below the output of the pipe, the flow through that part of the circuit would stop completely. Note that circulating pumps usually do not generate enough pressure to overcome air locks.
Vapor lock is a problem caused by liquid fuel changing state to vapor while still in the fuel delivery system of gasoline-fueled internal combustion engines.This disrupts the operation of the fuel pump, causing loss of feed pressure to the carburetor or fuel injection system, resulting in transient loss of power or complete stalling.
An air purge heating unit is used to ensure that the purge air remains at a temperature above the acid dew-point. This temperature is typically around 20 °C/68 °F. [2] If temperatures are below this point, the controls will be corroded by condensation of compounds in the flue gas. Heated air ensures that controls are dry during startup. [3]
If the throttling valve or device is located at the entry into a pressure vessel so that the flash evaporation occurs within the vessel, then the vessel is often referred to as a flash drum. [1] [2] If the saturated liquid is a single-component liquid (for example, propane or liquid ammonia), a part
This is most likely to occur on a carbureted engine in cold weather, after a running engine has been shut off briefly before being restarted. Doing so can cause the choke valve to configure the mixture for a cold engine start, despite higher actual temperatures, resulting in an overly rich mixture and flooded engine.
If the fluid is a liquid, a different type of limiting condition (also known as choked flow) occurs when the venturi effect acting on the liquid flow through the restriction causes a decrease of the liquid pressure beyond the restriction to below that of the liquid's vapor pressure at the prevailing liquid temperature.
Ad
related to: bad vapor canister purge valve symptoms causesebay.com has been visited by 1M+ users in the past month