Search results
Results from the WOW.Com Content Network
In the 1970s, Thorn Lighting introduced an energy-saving 8 ft retrofit tube in Europe. Designed to run on the existing 125 W (240 V) series ballast but with a different gas fill and operating voltage, the tube operated at only 100 W. Increased efficiency meant that the tube produced only 9% lumen reduction for a 20% power reduction. [ 7 ]
Tired light was an idea that came about due to the observation made by Edwin Hubble that distant galaxies have redshifts proportional to their distance.Redshift is a shift in the spectrum of the emitted electromagnetic radiation from an object toward lower energies and frequencies, associated with the phenomenon of the Doppler effect.
The transmitted light varies over the day; should this not be desired, light tubes can be combined with artificial light in a hybrid set-up. [ 27 ] [ 44 ] [ 45 ] [ 46 ] Some artificial light sources are marketed which have a spectrum similar to that of sunlight, at least in the human visible spectrum range, [ 47 ] [ 48 ] [ 49 ] as well as low ...
The latter use a standard light switch, and the on-board electronics chooses the light output level based on the number of times the switch is turned on and off quickly. Dimmable CFLs are not a 100% replacement for incandescent fixtures that are dimmed for "mood scenes" such as wall sconces in a dining area.
Fluorescent tubes are long, low-luminance sources compared with high intensity discharge lamps, incandescent and halogen lamps and high power LEDs. However, low luminous intensity of the emitting surface is useful because it reduces glare. Lamp fixture design must control light from a long tube instead of a compact globe.
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Tung-Sol provided Electron Tubes for the SLAC-71 UC-28, Particle Accelerators and High-Voltage Machines, a report in 1966 identified failures of 25 tubes on the accelerator, covered by warranty, and 60 total tubes on the two-mile accelerator, Mark IV accelerator, and test stands.
LED tubes. LED tube is a type of LED lamp used in fluorescent tube luminaires with G5 and G13 bases to replace traditional fluorescent tubes. [1] As compared to fluorescent tubes, the most important advantages of LED tubes are energy efficiency and long service life. LED tubes are sometimes also referred to as ‘LED fluorescent tubes’.