Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The Diagnostic Trouble Codes (DTC's) of OBD-I vehicles can usually be found without an expensive scan tool. Each manufacturer used their own Diagnostic Link Connector (DLC), DLC location, DTC definitions, and procedure to read the DTC's from the vehicle.
Clears diagnostic trouble codes (DTC's) from ECU memory. DTC grouping is used to loosely identify fault locations in undocumented ECU's. 0x14 00 00 00 to FF FF FF clears specific powertrain DTC's; 0x14 40 00 00 to 7F FF FF clears specific chassis DTC's; 0x14 80 00 00 to BF FF FF clears specific body DTC's
The Isuzu 6H is a family of inline six-cylinder diesel engines installed in Isuzu medium-duty trucks, and also installed in GM medium-duty trucks as the Duramax LG4. It is mated to the Allison 2500, 3000, and 3500 series transmissions.
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
Engine control unit is also called: . PCM: Power-train control module (Ford, GM, JLR) ECM: Engine control module; Injection control unit (Peugeot, [2] Citroën, Fiat, Alfa, Lancia)
Allison 1000 attached to Duramax 6.6 Diesel. The LMM (engine code "6") debuted part way through 2007 and ended production with the start of the 2011 calendar year and is mated to the 6-speed Allison transmission. The LMM was the only Duramax offered for model years 2007–2010. [6] A version was used in the Trident Iceni. [7]
Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors. This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.