Search results
Results from the WOW.Com Content Network
Simple model for transpression: strike-slip zone with an additional and simultaneous shortening across the zone. Also induces vertical uplift. In geology, transpression is a type of strike-slip deformation that deviates from simple shear because of a simultaneous component of shortening perpendicular to the fault plane. This movement ends up ...
Strike-slip tectonics or wrench tectonics is a type of tectonics that is dominated by lateral (horizontal) movements within the Earth's crust (and lithosphere).Where a zone of strike-slip tectonics forms the boundary between two tectonic plates, this is known as a transform or conservative plate boundary.
Strike-slip faults with left-lateral motion are also known as sinistral faults and those with right-lateral motion as dextral faults. [19] Each is defined by the direction of movement of the ground as would be seen by an observer on the opposite side of the fault. A special class of strike-slip fault is the transform fault when it forms a plate ...
Lateral strike-slip faults. Strike-slip faults occur when the blocks slide against each other laterally, parallel to the plane. The direction of the slip can be observed from either side of the fault, with the far block moving to the left indicating a left lateral slip, and the converse indicating a right lateral slip. See animation here [5]
Diagram of fault geometry (in map view) that leads to transtension at the bend or step-over. Releasing bends are transtensional structures that form where the orientation of a strike-slip fault becomes oblique to the regional slip vector causing local extension (such as a right stepping bend on a right-lateral fault). [1]
Strike-slip faults are commonly almost vertically inclined faults, where the main displacement and slip is in the horizontal direction, parallel to the strike of the fault. Depending on the movement of the fault blocks relative to the fault plane, strike-slip faults can be classified as either sinistral (left-lateral displacement) or dextral ...
Schematic illustration of the two strike-slip fault types. The view is of the Earth's surface from above. In geology, the terms sinistral and dextral refer to the horizontal component of the movement of blocks on either side of a fault or the sense of movement within a shear zone. These are terms of relative direction, as the movement of the ...
A sag pond is formed along a strike-slip fault, which may create a depression in the earth. [ 4 ] [ 5 ] When water enters the depression from rivers, streams, rainfall or snowfall, it fills the low-lying area, and a pond is the result.