enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Surge protector - Wikipedia

   en.wikipedia.org/wiki/Surge_protector

   Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS)) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...

3. Power strip - Wikipedia

   en.wikipedia.org/wiki/Power_strip

   A North American power strip with two USB power ports that includes a built in surge protector. A power strip (also known as a multi-socket, power board and many other variations [a]) is a block of electrical sockets that attaches to the end of a flexible cable (typically with a mains plug on the other end), allowing multiple electrical devices to be powered from a single electrical socket.

4. Safeguard Your Electronics With These Power Strips and Surge ...

   www.aol.com/lifestyle/avoid-frying-devices-power...

   For premium support please call: 800-290-4726 more ways to reach us

5. Talk:Surge protector - Wikipedia

   en.wikipedia.org/wiki/Talk:Surge_protector

   120V USA surge protectors shouldn't be used in 220V. Surge protectors have a cutoff voltage < 330VAC peak which is very close to the operating voltage peak of 220V, 311VAC peak, so it may survive being plugged in, but depending on the type of MOVs installed its inevitable it will blow. Better surge protectors use much lower clamping voltages ...

6. Extend the Life of Your Appliances and Electronics With ... - AOL

   www.aol.com/lifestyle/extend-life-appliances...

   For premium support please call: 800-290-4726 more ways to reach us

7. Network protector - Wikipedia

   en.wikipedia.org/wiki/Network_protector

   The network protector is installed to protect the stability and reliability of the secondary grid by preventing power flow away from the customers and into the primary feeders. If there is a fault on the primary feeder, the substation circuit-breaker is meant to open, disconnecting the primary feeder from one side.