Search results
Results from the WOW.Com Content Network
The generic term stripline in modern usage usually refers to the form then known as triplate. [22] Early stripline directly coupled resonator filters were end-coupled, but the length was reduced and the compactness successively increased with the introduction of parallel-coupled line filters, [23] interdigital filters, [24] and comb-line ...
Via fences are used to shield microstrip and stripline transmission lines, guard edges of printed circuit boards, shield functional circuit units from each other, and to form the walls of waveguides integrated into a planar format. Via fences are cheap and easy to implement, but use up board space and are not as effective as solid metal walls.
A stripline circuit uses a flat strip of metal which is sandwiched between two parallel ground planes.The insulating material of the substrate forms a dielectric.The width of the strip, the thickness of the substrate and the relative permittivity of the substrate determine the characteristic impedance of the strip which is a transmission line.
Stripline illustrating the incremental Wheeler inductance rule. The incremental inductance rule, attributed to Harold Alden Wheeler [1] by Gupta [2]: 101 and others [3]: 80 is a formula used to compute skin effect resistance and internal inductance in parallel transmission lines when the frequency is high enough that the skin effect is fully developed.
A stripline circuit uses a flat strip of metal which is sandwiched between two parallel ground planes. The insulating material of the substrate forms a dielectric. The width of the strip, the thickness of the substrate and the relative permittivity of the substrate determine the characteristic impedance of the strip which is a transmission line.
Early uses of the term Nyquist frequency, such as those cited above, are all consistent with the definition presented in this article.Some later publications, including some respectable textbooks, call twice the signal bandwidth the Nyquist frequency; [6] [7] this is a distinctly minority usage, and the frequency at twice the signal bandwidth is otherwise commonly referred to as the Nyquist rate.
Stripline was the brand name of AIL who made air stripline. Microstrip was made by ITT. Later, dielectric-filled stripline under the brand name triplate was manufactured by Sanders Associates. Stripline became a generic term for dielectric filled stripline and air stripline or suspended stripline is now used to distinguish the original type. [93]
In a stripline circuit, a stub may be placed just before an output connector to compensate for minor mismatches due to the device's output load or the connector itself. Stubs can match a load impedance to the transmission line characteristic impedance. The stub is positioned a distance from the load.