Search results
Results from the WOW.Com Content Network
A pipe might become overfilled if it is on a side of the drain which receives a much larger volume of water, such as one pipe being closer to an uphill slope, or closer to a roofline that drips near the French drain. When a pipe becomes overfilled, water can seep sideways into a parallel pipe, as a form of load-balancing, so that neither pipe ...
A French drain, PVC pipe, or other drainage system is installed in the newly made channel. The installed drain is covered with new cement. The installed drain is covered with new cement. The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the ...
The installed coupling housing encases the gasket and engages the grooves around the pipe to create a leakproof seal in a self-restrained pipe joint. There are two types of grooved coupling; a flexible coupling allows a limited amount of angular movement, and a rigid coupling does not allow movement and may be used where joint immobility is ...
A sanitary sewer is an underground pipe or tunnel system for transporting sewage from houses and commercial buildings (but not stormwater) to a sewage treatment plant or disposal. Sanitary sewers are a type of gravity sewer and are part of an overall system called a "sewage system" or sewerage .
These devices avoid negative pressure in the drain pipe by venting room air into the drain pipe (behind the trap). A "Chicago Loop" is another alternative. When a trap is installed on a fixture that is not routinely used—such as a floor drain—the eventual evaporation of the water in the trap must be considered.
A main component of the base section is a channel that provides a smooth conduit for wastewater to flow from inlet pipe to outlet pipe. The channel is in a U shape formed by a "half pipe" as if a pipe is cut in half and left with the bottom half. The width of the channel should match the inside diameter of the inlet and outlet pipes.
Agricultural water management in the Philippines is primarily focused on irrigation. The country has 3.126 million hectares of irrigable land, 50% (1.567 million hectares) of which already has irrigation facilities. 50% of irrigated areas are developed and operated by the government through the National Irrigation System (NIS). 36% is developed by the government and operated by irrigators ...
The Metropolitan Waterworks and Sewerage System [1] (Tagalog: Pangasiwaan ng Tubig at Alkantarilya sa Kalakhang Maynila), [5] formerly known as the National Waterworks and Sewerage System Authority (NAWASA), is the government agency that is in charge of water privatization in Metro Manila and nearby provinces of Cavite and Rizal in the Philippines.