enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.

3. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   Hex keys of various sizes with ball ends. Tamper-resistant hex screws have a protruding pin in the center of the hex recess that prevents insertion of standard hex keys; as such, they can only be fastened and removed with a special key that has a recess for the pin. A similar "center pin reject" security feature is also used on torx screws.

4. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]

5. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Studs with a length of engagement equal to about 1 d: Active: DIN 939: Studs with a length of engagement equal to about 1,25 d: Active: DIN 946: Determination of coefficient of friction of bolt/nut assemblies under specified conditions: Withdrawn: DIN EN ISO 16047: ISO 16047: DIN 960: M8x1 to M100x4 hexagon head bolts with fine pitch thread ...

6. Keyway - Wikipedia

   en.wikipedia.org/wiki/Keyway

   Keyway may refer to: A part of a keyed joint used to connect a rotating machine element to a shaft; see key (engineering) A keyhole , a hole or aperture (as in a door or lock) for receiving a key; see lock and key

7. Go/no-go gauge - Wikipedia

   en.wikipedia.org/wiki/Go/no-go_gauge

   The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance. This may be initially expressed on the parts drawing in a number of styles; three possibilities may be 12.75 ± 0.15 mm; 12.60 +0.30 −0.00 mm; 12.90 +0.00

8. Dollar General, Dollar Tree's consumers continue to tighten ...

   www.aol.com/finance/dollar-general-dollar-trees...

   The Dollar General convenience store logo is displayed on a truck on Aug. 30, 2024, in Austin, Texas. (Brandon Bell/Getty Images) (Brandon Bell via Getty Images)

9. Broaching (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Broaching_(metalworking)

   Also, there are limits on the size of internal cuts. Common internal holes can range from 0.125 to 6 in (3.2 to 152.4 mm) in diameter but it is possible to achieve a range of 0.05 to 13 in (1.3 to 330.2 mm). Surface broaches' range is usually 0.075 to 10 in (1.9 to 254.0 mm), although the feasible range is 0.02 to 20 in (0.51 to 508.00 mm).