Search results
Results from the WOW.Com Content Network
Cars and trucks using direct air cooling (without an intermediate liquid) were built over a long period from the very beginning and ending with a small and generally unrecognized technical change. Before World War II, water-cooled cars and trucks routinely overheated while climbing mountain roads, creating geysers of boiling cooling water. That ...
On vintage cars you may find a bellows type thermostat, which has corrugated bellows containing a volatile liquid such as alcohol or acetone. These types of thermostats do not work well at cooling system pressures above about 7 psi. Modern motor vehicles typically run at around 15 psi, which precludes the use of the bellows type thermostat.
A coolant is a substance, typically liquid, that is used to reduce or regulate the temperature of a system. An ideal coolant has high thermal capacity, low viscosity, is low-cost, non-toxic, chemically inert and neither causes nor promotes corrosion of the cooling system. Some applications also require the coolant to be an electrical insulator.
However, if the coolant engages in nucleate boiling but does not form a film, this helps disrupt the coolant boundary layer and the gas bubbles formed rapidly collapse; this can triple the maximum heat flow. However, many modern engines with turbopumps use supercritical coolants, and these techniques can be seldom used.
The compression assembly system aims to decrease the thermal contact resistance between the thermoelectric module and the heat exchanger surfaces. In coolant-based ATEGs, the cold side heat exchanger uses engine coolant as the cooling fluid, while in exhaust-based ATEGs, the cold-side heat exchanger uses ambient air as the cooling fluid.
Although the automotive industry seems like it’s slowly making a shift towards battery-powered vehicles, hydrogen fuel cell vehicles could be another great alternative to gas-powered cars.
The College Football Playoff bracket is finally set and Caroline Fenton, Jason Fitz & Adam Breneman react to the final rankings and share what things the committee got right and which were wrong.
The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.