Search results
Results from the WOW.Com Content Network
Known as "10 mm figure scale" in wargaming circles. [citation needed] 1:160: 1.905 mm: Model railways (N) American and European model trains in N scale. Commonly used for mini armor. 10 mm to 12 mm figure scale for miniature wargaming. 1:152: 2.005 mm 2mm scale / British N scale railway modeling. 1:150: 2.032 mm: Model railways (Japanese N)
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
The recent formula used by the Brannock device assumes a foot length of 2 barleycorns less than the length of the last; thus, men's size 1 is equivalent to a last's length of 8 + 1 ⁄ 3 in (21.17 cm) and foot's length of 7 + 2 ⁄ 3 in (19.47 cm), and children's size 1 is equivalent to 4 + 1 ⁄ 4 in (10.8 cm) last's length and 3 + 7 ⁄ 12 in ...
3.5 mm or 3.5mm may refer to: HO scale , in rail transport modelling, 1:87 scale, with rails 16.5 mm apart, representing standard gauge 3.5 mm jack , used on audio and mobile telephony equipment
It was capable of firing a 3.5 in × 23.6 in (90 mm × 600 mm) shell 62,474 ft (19,042 m) horizontally, or a maximum altitude of 43,500 ft (13,300 m). The 90 mm gun was the US Army's primary heavy anti-aircraft gun from just prior to the opening of World War II into 1946, complemented by small numbers of the much larger 120 mm M1 gun .
One study analysing the self-reported Kinsey data set found that the average penis of a homosexual man was larger than the average penis of their heterosexual counterparts (6.32 inches [16.05 cm] in length amongst gay men versus 5.99 in [15.21 cm] in heterosexuals, and 4.95 inches [12.57 cm] circumference amongst gay men versus 4.80 in [12.19 ...
In addition, 10 mm (0.393 in), and letter X (0.397 in) will work well, although major minus pitch by itself does not tell you this; but the 90% ± 2 pp guideline supports it. For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use.
The 2.5 mm or sub-miniature sizes were similarly popularized on small portable electronics. They often appeared next to a 3.5 mm microphone jack for a remote control on-off switch on early portable tape recorders; the microphone provided with such machines had the on-off switch and used a two-pronged connector with both the 3.5 and 2.5 mm plugs.