Search results
Results from the WOW.Com Content Network
Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [2] For example, a catheter with a French size of 9 would have an outer diameter of approximately 3 mm. While the French scale aligns closely with the metric system, it introduces redundancy and the potential for rounding errors.
The French National Print Office adopted a point of 2 ⁄ 5 mm or 0.400 mm in about 1810 and continues to use this measurement today (though "recalibrated" to 0.398 77 mm). [ 21 ] [ 22 ] [ 23 ] Japanese [ 24 ] and German [ 9 ] [ 16 ] [ 18 ] standardization bodies instead opted for a metric typographic base measure of exactly 1 ⁄ 4 mm or 0.250 ...
For example, "agate" and "ruby" used to be a single size "agate ruby" of about 5 points; [2] metal type known as "agate" later ranged from 5 to 5.8 points. The sizes were gradually standardized as described above. [ 3 ]
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
In the United States, Canada, and Mexico, ring sizes are specified using a numerical scale with 1 ⁄ 4 steps, where whole sizes differ by 0.032 inches (0.81 mm) of internal diameter, equivalent to 0.1005 inches (2.55 mm) of internal circumference.
This can be confusing because it refers to two distinct measurements as if they were measured with the same unit. Normally one would think a 3 by 6 advertisement would be 3 inches wide by 6 inches high — but in reality it's actually about 5.5 inches wide by 6 inches high. In writing, an "×" is usually used to separate the two figures ...
While HO scale is a 1:87 scale (3.5 mm to 1 foot), resulting in a 16.5 mm (0.65 in) gauge from real life prototype 1,435 mm (4 ft 8 + 1 ⁄ 2 in) standard gauge standard gauge. Conversely, modeling standard gauge in Lego trains would yield a scaling of (37.5:1435 =) 1:38.3.