Ad
related to: how to calculate ssb frequency in excel worksheet
Search results
Results from the WOW.Com Content Network
where f 0 is the output frequency, Q l is the loaded quality factor, f m is the offset from the output frequency (Hz), f c is the 1/f corner frequency, F is the noise factor of the amplifier, k is the Boltzmann constant, T is absolute temperature, and P s is the available power at the sustaining amplifier input. [3]
In radio communications, single-sideband modulation (SSB) or single-sideband suppressed-carrier modulation (SSB-SC) is a type of modulation used to transmit information, such as an audio signal, by radio waves. A refinement of amplitude modulation, it uses transmitter power and bandwidth more efficiently.
The power of an AM radio signal plotted against frequency. fc is the carrier frequency, fm is the maximum modulation frequency. In radio communications, a sideband is a band of frequencies higher than or lower than the carrier frequency, that are the result of the modulation process. The sidebands carry the information transmitted by the radio ...
Amplitude-companded single-sideband (ACSB) is a narrowband modulation method using a single-sideband with a pilot tone, allowing an expander in the receiver to restore the amplitude that was severely compressed by the transmitter.
Failure of the BFO to match the original carrier frequency when receiving such a signal will cause a heterodyne. Suppressed carriers are often used for single sideband (SSB) transmissions, such as for amateur radio on shortwave. That system is referred to in full as SSB suppressed carrier or (SSB-SC).
A Compatible sideband transmission, also known as amplitude modulation equivalent (AME) or Single sideband reduced-carrier (SSB-RC), is a type of single sideband RF modulation in which the carrier is deliberately reinserted at a lower level after its normal suppression to permit reception by conventional AM receivers. The general convention is ...
The frequency of the local oscillator must be the same as the frequency of the carrier, or else the output message will fade in and out in the case of AM, or be frequency shifted in the case of SSB; Once the frequency is matched, the phase of the carrier must be obtained, or else the demodulated message will be attenuated, but the noise will ...
Therefore, the base frequency f b is 300 MHz (the baseband frequency to relate from) and the offset is 0.0125 MHz (12.5 kHz) and thus we get the relation: = Inseting the frequency for the first channel 390.0125 MHz gives us an ARFCN of 3600.
Ad
related to: how to calculate ssb frequency in excel worksheet