Search results
Results from the WOW.Com Content Network
where f 0 is the output frequency, Q l is the loaded quality factor, f m is the offset from the output frequency (Hz), f c is the 1/f corner frequency, F is the noise factor of the amplifier, k is the Boltzmann constant, T is absolute temperature, and P s is the available power at the sustaining amplifier input. [3]
In radio communications, single-sideband modulation (SSB) or single-sideband suppressed-carrier modulation (SSB-SC) is a type of modulation used to transmit information, such as an audio signal, by radio waves. A refinement of amplitude modulation, it uses transmitter power and bandwidth more efficiently.
The power of an AM radio signal plotted against frequency. fc is the carrier frequency, fm is the maximum modulation frequency. In radio communications, a sideband is a band of frequencies higher than or lower than the carrier frequency, that are the result of the modulation process. The sidebands carry the information transmitted by the radio ...
Note that since this resultant wave is continuously phase shifting at a steady rate, effectively the frequency has been changed: it has been frequency modulated. And if the IQ data itself has some frequency (e.g. a phasor) then the carrier also can be frequency modulated. So I/Q data is a complete representation of how a carrier is modulated ...
Failure of the BFO to match the original carrier frequency when receiving such a signal will cause a heterodyne. Suppressed carriers are often used for single sideband (SSB) transmissions, such as for amateur radio on shortwave. That system is referred to in full as SSB suppressed carrier or (SSB-SC).
Time domain statistical multiplexing (packet mode communication) is similar to time-division multiplexing (TDM), except that, rather than assigning a data stream to the same recurrent time slot in every TDM, each data stream is assigned time slots (of fixed length) or data frames (of variable lengths) that often appear to be scheduled in a randomized order, and experience varying delay (while ...
The frequency of the local oscillator must be the same as the frequency of the carrier, or else the output message will fade in and out in the case of AM, or be frequency shifted in the case of SSB; Once the frequency is matched, the phase of the carrier must be obtained, or else the demodulated message will be attenuated, but the noise will ...
Most amateur digital modes are transmitted by inserting audio into the microphone input of a radio and using an analog scheme, such as amplitude modulation (AM), frequency modulation (FM), or single-sideband modulation (SSB). Amateur teleprinting over radio (AMTOR) D-STAR (Digital Data) a high speed (128 kbit/s), data-only mode.