enow.com Web Search

  1. Ads

    related to: speaker impedance 4 ohm vs 8

Search results

  1. Results from the WOW.Com Content Network
  2. Electrical characteristics of dynamic loudspeakers - Wikipedia

    en.wikipedia.org/wiki/Electrical_characteristics...

    If a home hi-fi amplifier specifies 8 ohm or greater loads, care should be taken that loudspeakers with a lower impedance are not used, lest the amplifier be required to produce more current than it was designed to handle. Using a 4 ohm loudspeaker system on an amplifier specifying 8 ohms or greater could lead to amplifier failure.

  3. Damping factor - Wikipedia

    en.wikipedia.org/wiki/Damping_factor

    The loudspeaker's nominal load impedance (input impedance) of is usually around 4 to 8 Ω, although other impedance speakers are available, sometimes dropping as low as 1 Ω or 2 Ω. However, the impedance rating of a loudspeaker is simply a number that indicates the nominal minimum impedance of that loudspeaker over a representative portion of ...

  4. Loudspeaker - Wikipedia

    en.wikipedia.org/wiki/Loudspeaker

    Impedance – typically 4 Ω (ohms), 8 Ω, etc. [43] ... The voltage used is often 2.83 V RMS, which results in 1 watt into a nominal 8 Ω speaker impedance ...

  5. Line level - Wikipedia

    en.wikipedia.org/wiki/Line_level

    Connecting a low-impedance load such as a loudspeaker (usually 4 to 8 Ω) to a line out will essentially short circuit the output circuit. Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal ...

  6. Thiele/Small parameters - Wikipedia

    en.wikipedia.org/wiki/Thiele/Small_parameters

    American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...

  7. Speaker wire - Wikipedia

    en.wikipedia.org/wiki/Speaker_wire

    [citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.

  1. Ads

    related to: speaker impedance 4 ohm vs 8