Search results
Results from the WOW.Com Content Network
Depth of discharge (DoD) is an important parameter appearing in the context of rechargeable battery operation. Two non-identical definitions can be found in commercial and scientific sources. The depth of discharge is defined as: the maximum fraction of a battery's capacity (given in Ah) which is removed from the charged battery on a regular basis.
A 20-volt level was added in a revision named "class B" of the specification. [12] [13] The voltage range of the successor Pump Express Plus 2.0 is between 5 volts and 20 volts, with 0.5 volts steps. The Quick Charge 3.0 protocol supports finer-grain voltage levels with 0.2 volts steps and has a lower minimum voltage of approximately 3.3 volt.
The first stage is referred to as "bulk absorption"; the charging current is held high and constant and is limited by the capacity of the charger. When the voltage on the battery reaches its outgassing voltage (2.22 volts per cell) the charger switches to the second stage, and the voltage is held constant (2.40 volts per cell).
In a battery electric vehicle (BEV), the state of charge indicates the remaining energy in the battery pack. [4] It is the equivalent of a fuel gauge.. The state of charge can help to reduce electrical car's owners' anxiety when they are waiting in the line or stay at home since it will reflect the progress of charging and let owners know when it will be ready. [5]
B Battery: Eveready 762-S: 45 V: Threaded posts H: 146 L: 104.8 W: 63.5 Used to supply plate voltage in vintage vacuum tube equipment. Origin of the term B+ for plate voltage power supplies. Multiple B batteries may be connected in series to provide voltages as high as 300 V DC. Some versions have a tap at 22.5 volts. GB Battery: C Battery ...
Overcharging a rechargeable battery; Overcharge, charging a customer too much This page was last ... This page was last edited on 28 March 2018, at 20:05 (UTC).
Most manufacturers claim that overcharging is safe at very low currents, below 0.1 C (C/10) (where C is the current equivalent to the capacity of the battery divided by one hour). [23] The Panasonic NiMH charging manual warns that overcharging for long enough can damage a battery and suggests limiting the total charging time to 10–20 hours. [22]
The SI unit of work per unit charge is the joule per coulomb, where 1 volt = 1 joule (of work) per 1 coulomb of charge. [citation needed] The old SI definition for volt used power and current; starting in 1990, the quantum Hall and Josephson effect were used, [10] and in 2019 physical constants were given defined values for the definition of all SI units.