Search results
Results from the WOW.Com Content Network
Edge-banding or edge tape can refer to the narrow strip of material being used as the veneer. [2] Edge banding is used to cover the exposed sides of materials such as plywood, particle board, or MDF. This increases durability and gives the appearance of a solid or more valuable material. Common substitutes for edge banding include face frames ...
Using a drawknife in making a flatbow. A drawknife is commonly used to remove large slices of wood for flat faceted work, to debark trees, or to create roughly rounded or cylindrical billets for further work on a lathe, or it can shave like a spokeshave plane, where finer finishing is less of concern than a rapid result.
Screwfix Direct Limited, trading as Screwfix, is a retailer of trade tools, accessories and hardware products based in the United Kingdom. [6] Founded in 1979 as the Woodscrew Supply Company, the company was acquired in July 1999 by Kingfisher plc , which also owns B&Q , and is listed on the London Stock Exchange .
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers , which run perpendicular to the primary joists.
A laminate trimmer equipped with a bearing-guided flush trimming bit can be used to cut the veneer to its final size. [2] The bearing guides the bit around the outside edge of the wood substrate, making a clean cut exactly along the edge. Laminate trimmers excel at this task due to their light weight and one-handed operation.
The stiles and rails often have a profile cut into the inside edge of the outside face - usually a smaller version to match the profile of the panel. In some panel styles, a profile may also be cut on the outside edge of the outside face. [2] In modern cabinetry, the cope and stick joinery is achieved with a set of special router cutters.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The book-cutting machine works with three knives and uses the knife-cut principle. The knife-cut principle operates with only one knife per edge which cuts against a rubber surface. This surface supports the cut force. The three-knife-trim is performed in one step. The block is aligned and fixed by the pressure bar.