Search results
Results from the WOW.Com Content Network
The Chrysler A engine is an OHV small-block V8 gasoline engine built by Chrysler from 1956 until 1967. It featured polyspherical combustion chambers , and was offered in displacements from 276.1 cu in (4.5 L) to 325.2 cu in (5.3 L), and in various high-power configurations.
The "LA" and "A" production overlapped from 1964–1966 in the U.S. and through 1967 in export vehicles when the "A" 318 engine was phased out. [3] The basic design of the LA engine would go unchanged through the development of the "Magnum" upgrade (1992–1993), and continue into the 2000s with changes to enhance power and efficiency. [2]
In a later reversal of this practice, the Engine Division eventually served as a third-party supplier to other makers of farm and industrial machinery, most notably Cockshutt and LeRoi. Allis-Chalmers (and Buda) produced heavy-duty engine designs that were built to handle a variety of fuel types (generally gasoline , diesel fuel , or liquefied ...
In 1968, the 273 was replaced by the 318 cu in (5.2 L) LA engine as the smallest V8 available, and the new 340 cu in (5.6 L) LA four-barrel was released. The 383 Super Commando engine was upgraded with the intake manifold, camshaft, and cylinder heads from the Road Runner and Super Bee , but the more restrictive exhaust manifolds specific to ...
The "GEN-3" engines were available in Jeep utility vehicles starting in 1971. [3] It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5]
A narrower range of engines was offered: the base power plant was the 225 cu in (3.7 L) slant-6, now with top-fed hydraulic tappets, and the 318 cu in (5.2 L) and 360 cu in (5.9 L) LA-series V8s. The slant-6 was replaced by the 3.9 L (237 cu in) V6 for 1988; in 1992, it and the V8s became Magnum engines.
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
A special build 327 was built for GMH for the final run of the HK GTS327 by the Canadian McKinnon Industries. It was a lower compression version of the 1968 engine first used on the HK GTS327, and was dressed as a 1969 engine sporting all 1969 parts. The 327 was replaced in the mid-1969 HT Monaro by the 350 L48 developing 300 hp (224 kW).