Search results
Results from the WOW.Com Content Network
The Chrysler A engine is an OHV small-block V8 gasoline engine built by Chrysler from 1956 until 1967. It featured polyspherical combustion chambers , and was offered in displacements from 276.1 cu in (4.5 L) to 325.2 cu in (5.3 L), and in various high-power configurations.
The "LA" and "A" production overlapped from 1964–1966 in the U.S. and through 1967 in export vehicles when the "A" 318 engine was phased out. [3] The basic design of the LA engine would go unchanged through the development of the "Magnum" upgrade (1992–1993), and continue into the 2000s with changes to enhance power and efficiency. [2]
In 1968, the 273 was replaced by the 318 cu in (5.2 L) LA engine as the smallest V8 available, and the new 340 cu in (5.6 L) LA four-barrel was released. The 383 Super Commando engine was upgraded with the intake manifold, camshaft, and cylinder heads from the Road Runner and Super Bee , but the more restrictive exhaust manifolds specific to ...
The "GEN-3" engines were available in Jeep utility vehicles starting in 1971. [3] It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5]
A narrower range of engines was offered: the base power plant was the 225 cu in (3.7 L) slant-6, now with top-fed hydraulic tappets, and the 318 cu in (5.2 L) and 360 cu in (5.9 L) LA-series V8s. The slant-6 was replaced by the 3.9 L (237 cu in) V6 for 1988; in 1992, it and the V8s became Magnum engines.
The code E68 400 cu in 260 hp engine was the biggest Plymouth offered with the 4-speed, which could also be had with the 340 (1973), and 360 (1974) engines. The 318 was equipped with a 3-speed manual transmission as standard (though very few were built), and the TorqueFlite as an option, though at least one 318 engine 1974 car was built with ...
A special build 327 was built for GMH for the final run of the HK GTS327 by the Canadian McKinnon Industries. It was a lower compression version of the 1968 engine first used on the HK GTS327, and was dressed as a 1969 engine sporting all 1969 parts. The 327 was replaced in the mid-1969 HT Monaro by the 350 L48 developing 300 hp (224 kW).
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.