Search results
Results from the WOW.Com Content Network
One acre equals 1 ⁄ 640 (0.0015625) square mile, 4,840 square yards, 43,560 square feet, [2] or about 4,047 square metres (0.4047 hectares) (see below).While all modern variants of the acre contain 4,840 square yards, there are alternative definitions of a yard, so the exact size of an acre depends upon the particular yard on which it is based.
Land equivalent ratio. The FAO defines land equivalent ratio (LER) as: [2] the ratio of the area under sole cropping to the area under intercropping needed to give equal amounts of yield at the same management level. It is the sum of the fractions of the intercropped yields divided by the sole-crop yields.
As the name suggests, an acre-foot is defined as the volume of one acre of surface area to a depth of one foot.. Since an acre is defined as a chain by a furlong (i.e. 66 ft × 660 ft or 20.12 m × 201.17 m), an acre-foot is 43,560 cubic feet (1,233.5 m 3).
The acre is also commonly used to measure land areas, where 1 acre = 4,840 square yards = 43,560 square feet. An acre is approximately 40% of a hectare. On the atomic scale, area is measured in units of barns, such that: [13] 1 barn = 10 −28 square meters. The barn is commonly used in describing the cross-sectional area of interaction in ...
One of the reasons for creating sections of 640 acres (260 ha) was the ease of dividing into halves and quarters while still maintaining a whole number of acres. A section can be halved seven times in this way, down to a 5-acre (2 ha) parcel, or half of a quarter-quarter-quarter section—an easily surveyed 50-square-chain (2 ha) area. This ...
Floor area ratio (FAR) is the ratio of a building's total floor area (gross floor area) to the size of the piece of land upon which it is built. It is often used as one of the regulations in city planning along with the building-to-land ratio. [1] The terms can also refer to limits imposed on such a ratio through zoning.
Build-out applies land use or zoning assumptions about density to the available land area. The build-out calculation may deduct land due to physical constraints to development (e.g. sensitive natural resources), potential infrastructure dedications (e.g. streets, public open space, or stormwater management structures), and practical design considerations (e.g. lot layout inefficiencies).
A farmer’s crop acreage base is reduced by the portion of cropland placed in the Conservation Reserve Program (CRP), but increased by CRP base acreage leaving the CRP. Farmers have the choice of base acreage used to calculate Production Flexibility Contract payments for crop year 2002, or the average of acres planted for crop years 1998 ...