enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gastronorm - Wikipedia

   en.wikipedia.org/wiki/Gastronorm

   The gastronorm standard was first introduced in Switzerland in 1964 and became an official European standard in 1993 with the EN 631 standard. [ 1 ] [ 2 ] [ 3 ] The basic format is called "GN 1/1" and measures 530×325 mm, with other Gastronorm sizes being multiples and submultiples of this basic module size.

3. 19-inch rack - Wikipedia

   en.wikipedia.org/wiki/19-inch_rack

   There is little evidence that the dimensions of these early racks were standardized. Telephone equipment racks (1923) The 19-inch rack format with rack-units of 1.75 inches (44.45 mm) was established as a standard by AT&T around 1922 in order to reduce the space required for repeater and termination equipment in a telephone company central ...

4. Kick space - Wikipedia

   en.wikipedia.org/wiki/Kick_space

   Traditionally, a kick space is allowed for in modern cabinet designs by creating a separate, recessed platform upon which one's cabinetry may rest. The kick space is intended to prevent potential toe injuries and allow for closer proximity to a countertop (the toes being the furthest-extending ground-level human body parts). [2]

5. Countertop - Wikipedia

   en.wikipedia.org/wiki/Countertop

   When installed in a kitchen on standard (U.S) wall-mounted base unit cabinets, countertops are typically about 25–26 inches (640–660 millimetres) from front to back and are designed with a slight overhang on the front (leading) edge. This allows for a convenient reach to objects at the back of the countertop while protecting the base ...

6. 32 mm cabinetmaking system - Wikipedia

   en.wikipedia.org/wiki/32_mm_cabinetmaking_system

   In addition to the 32 mm standard, there are other but less frequently used systems (System 25, ip20 etc.). [ 1 ] [ 2 ] [ 3 ] The system allows reconfigurable shelf placement and spacing. The system was developed by fitting, machine and furniture manufacturers, and serves to standardize both component dimensions and production processes.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

8. HuffPost Data

   projects.huffingtonpost.com

   Interactive maps, databases and real-time graphics from The Huffington Post

9. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...