Search results
Results from the WOW.Com Content Network
A cylinder with longitudinal draft Profile view of a drafted cylinder with the draft dimension. In engineering, draft is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). Consider the fabrication of a hollow plastic box, without lid.
However, cars registered before this date are taxed based on engine displacement. Cars under 1549 cm 3 qualify for a lower tax rate. [3] In Japan, the engine displacement is one of the factors (along with overall vehicle size and power output) used to determine the vehicle size class and therefore the cost of road tax for the vehicle.
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.
The cylinder in a steam engine is made pressure-tight with end covers and a piston; a valve distributes the steam to the ends of the cylinder. Cylinders were cast in cast iron and later in steel. The cylinder casting can include other features such as valve ports and mounting feet.
Variable compression ratio (VCR) is a technology to adjust the compression ratio of an internal combustion engine while the engine is in operation. This is done to increase fuel efficiency while under varying loads. Variable compression engines allow the volume above the piston at top dead centre to be changed. Higher loads require lower ratios ...
This engine has a bore and stroke of 71 mm × 84 mm (2.8 in × 3.3 in) stroke giving it a bore/stroke ratio of 0.845:1. Some rear-wheel-drive cars that borrow engines from front-wheel-drive cars (such as the Mazda MX-5) use an undersquare design.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
In an engine designed to use the squish effect, at top dead centre the piston crown comes very close (typically less than 1 mm [2]) to the cylinder head. The gases are suddenly "squished" out within the combustion chamber , creating turbulence which promotes thorough air-fuel mixing, a factor beneficial to efficient combustion .