enow.com Web Search

  1. Ads

    related to: bathroom sink water supply lines height and width calculator

Search results

  1. Results from the WOW.Com Content Network
  2. Air gap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Air_gap_(plumbing)

    Water cannot flow from the sink to the tap in normal circumstances, even if the water supply loses pressure. An air gap , as related to the plumbing trade, is the unobstructed vertical space between the water outlet and the flood level of a fixture . [ 1 ]

  3. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...

  4. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  5. Uniform Plumbing Code - Wikipedia

    en.wikipedia.org/wiki/Uniform_Plumbing_Code

    New alternate water sources for nonpotable applications and nonpotable rainwater catchment systems (Chapters 16, 17) based upon IAPMO’s Green Plumbing and Mechanical Code Supplement New Appendix L (sustainable practices) New minimum plumbing facilities table (Chapter 4) Water supply and drainage joint connection requirements (Chapters 6, 7) [12]

  6. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  7. Plumber - Wikipedia

    en.wikipedia.org/wiki/Plumber

    Plumbing work is defined in the Australian Standards (AS3500) Regulations 2013 and refers to any operation, work or process in connection with installation, removal, demolition, replacement, alteration, maintenance or repair to the system of pipes and fixtures that conveys clean water into and liquid waste out of a building.

  1. Ads

    related to: bathroom sink water supply lines height and width calculator