enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Compact Cassette tape types and formulations - Wikipedia

   en.wikipedia.org/wiki/Compact_Cassette_tape...

   Real cassette tapes invariably deviate from the references and require fine tuning of bias; recording a tape with improper bias increases distortion and alters frequency response. [26] A 1990 comparative test of 35 Type I tapes showed that their optimal bias levels were within 1 dB of the Type I reference, while Type IV tapes deviated from the ...

3. Audio tape specifications - Wikipedia

   en.wikipedia.org/wiki/Audio_tape_specifications

   The thickest tape normally used in cassettes is about 16-18 μm in thickness, and is used in C60 cassettes and in shorter lengths such as the C46. As the standard tape speed for a compact cassette is 1 + 7 ⁄ 8 ips (4.75 cm/s) and a C60 cassette records 30 minutes per side, a C60 cassette in theory holds 281 + 1 ⁄ 4 ft (85.73 m) of tape. In ...

4. Cassette tape - Wikipedia

   en.wikipedia.org/wiki/Cassette_tape

   These spools and their attendant parts are held inside a protective plastic shell which is 4 by 2.5 by 0.5 inches (10.2 cm × 6.35 cm × 1.27 cm) at its largest dimensions. The tape itself is commonly referred to as "eighth-inch" tape, supposedly 1 ⁄ 8 inch (0.125 in; 3.17 mm) wide, but actually slightly larger, at 0.15 inches (3.81 mm). [8]

5. Ampex - Wikipedia

   en.wikipedia.org/wiki/Ampex

   Internals of Ampex Fine Line F-44, a 3-head Ampex home-use audio tape recorder, c. 1965 AMPEX model 300 half-inch three-track recorder AMPEX 440 (2tr, 4tr) & 16-track MM 1000. The company's first tape recorder, the Ampex Model 200A, was first shipped in April 1948. The first two units, serial numbers 1 and 2, were used to record Bing Crosby's ...

6. Quarter-inch cartridge - Wikipedia

   en.wikipedia.org/wiki/Quarter-inch_cartridge

   The tape was originally 1 ⁄ 4 inch (6.35 mm) wide and anywhere from 300 to 1,500 feet (91 to 457 m) long. Data is written linearly along the length of the tape in one track [ 1 ] (mostly on pre-1980 equipment), or written "serpentine", one track at a time, the drive reversing direction at the end of the tape, and each track's data written in ...

7. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′. The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes.