Search results
Results from the WOW.Com Content Network
In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin In a pin tumbler lock, the key pin is in contact with the key. It has varying lengths, corresponding to the key's ...
In the early 1920s, Harry Soref started Master Lock off with the first laminated padlock. Plates that were punched from sheet metal were stacked and assembled. Holes that were formed in the middle of the plates made room to accommodate the locking mechanism. The entire stack of plates, loaded with the lock parts in it, was riveted together.
A practical attack exists to create a working master key for an entire system given only access to a single master-keyed lock, its associated change key, a supply of appropriate key blanks, and the ability to cut new keys. [2] Locksmiths may also determine cuts for a replacement master key, when given several different key examples from a given ...
A Wordlock letter combination lock.. A combination lock is a type of locking device in which a sequence of symbols, usually numbers, is used to open the lock. The sequence may be entered using a single rotating dial which interacts with several discs or cams, by using a set of several rotating discs with inscribed symbols which directly interact with the locking mechanism, or through an ...
In Europe, many small puzzle padlocks had front plate with a face or mask. The padlocks were designed to secure small bags or pouches and could be found across Europe with the most around the Danubian provinces and Aquileia. [2] They were often shaped like rings and may have been fitted around the mouth of a bag as a sort of tamper-proof seal. [3]
Many combination locks have three wheels, but the lock may be equipped with additional wheels, each with a drive pin and fly, in a similar manner. The number of wheels in the mechanism determines the number of specific dial positions that must be entered to open the lock, so a three-sequence combination is required for a three-wheel lock.
The Chubb detector lock is a variation of the lever lock which was designed to detect and prevent picking attempts. Lever locks can be drilled, but usually a template or stencil is required to mark the drilling point, as the lock mechanism is commonly mortised into the door and so it is harder to determine the point at which to drill.
The keyhole of a mechanical cam lock is usually the same as an ordinary padlock. A physical key is used to unlock the lock. The physical key has a notch or slot corresponding to the obstacle in the cam lock, allowing it to rotate freely in the lock. Different from mechanical cam locks, electronic cam locks use an electronic key to unlock.