Ads
related to: j pole antenna for 2 meter and 70cm ham radio systemproducts.bestreviews.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
Repeaters are found mainly in the VHF 6-meter (50–54 MHz), 2-meter (144–148 MHz), 1.25-meter band (1 1 ⁄ 4 meters) (220–225 MHz) and the UHF 70 centimeter (420–450 MHz) bands, but can be used on almost any frequency pair above 28 MHz. In some areas, 33 centimeters (902–928 MHz) and 23 centimeters (1.24–1.3 GHz) are also used for ...
One practical concern when comparing the 70-centimeter band to the 2-meter band is that a quarter-wavelength antenna is much less unwieldy at 70 centimeters than it is at 2 meters. Portable antennas for 2 meters are generally continuously loaded coil spring or " rubber duck " types, while on 70 centimeters they can be a full quarter wavelength.
This antenna radiates maximally in directions perpendicular to the antenna's axis, giving it a small directive gain of 2.15 dBi (2.15 dBi means that in the direction of maximum radiation, signal strength is 1.64× the signal from a directionless "isotropic" antenna). Doublet "Doublet" is a name radio amateurs sometimes use for a dipole antenna ...
As an "all-band" transceiver, the TS-2000 offers a maximum power output of 100 watts on the HF, 6 meters, and 2 meters bands, 50 watts on 70 centimeters, and, with the TS-2000X or the optional UT-20, 10 watts on the 1.2 GHz or 23 centimeters band. The (American version) radio's main receiver covers 30 kHz through 60 MHz, 142 MHz through 152 MHz ...
If it was infinitely thin the antenna would have an infinite input impedance, but the finite width gives typical, practical half wave whips an impedance of 800–1,500 ohms. These are usually fed through an impedance matching transformer or a quarter wave stub matching section (e.g. the J-pole antenna). An advantage is that because it acts as a ...
Ads
related to: j pole antenna for 2 meter and 70cm ham radio systemproducts.bestreviews.com has been visited by 1M+ users in the past month