Search results
Results from the WOW.Com Content Network
Electrochemiluminescence or electrogenerated chemiluminescence (ECL) is a kind of luminescence produced during electrochemical reactions in solutions. In electrogenerated chemiluminescence, electrochemically generated intermediates undergo a highly exergonic reaction to produce an electronically excited state that then emits light upon relaxation to a lower-level state.
Chemiluminescence (also chemoluminescence) is the emission of light (luminescence) as the result of a chemical reaction, i.e. a chemical reaction results in a flash or glow of light. A standard example of chemiluminescence in the laboratory setting is the luminol test.
Instead of increasing current levels, luminance is usually increased by combining multiple LEDs in one bulb. Solving the problem of efficiency droop would mean that household LED light bulbs would need fewer LEDs, which would significantly reduce costs. Researchers at the U.S. Naval Research Laboratory have found a way to lessen the efficiency ...
While most light bulb problems can be solved with a bulb swap, there's one so annoying it can drive even the nicest person crazy: buzzing. ... The easiest way to determine if this is the cause is ...
If one illuminates two parallel slits, the light from the two slits again interferes. Here the interference is a more pronounced pattern with a series of alternating light and dark bands. The width of the bands is a property of the frequency of the illuminating light. [20] (See the bottom photograph to the right.) Young's drawing of diffraction
Two ways of doing this are described in the ballast section below. The problem of flickering exists only when using the bulb in combination with magnetic ballast (electronic ballasts produce flicker-free light). HMI bulbs (running with magnetic ballast) present an inherent problem of possibly producing light on film or video with a noticeable ...
A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...
Closeup of the filament in a low pressure mercury gas-discharge lamp showing white thermionic emission mix coating on the central portion of the coil. Typically made of a mixture of barium, strontium and calcium oxides, the coating is sputtered away through normal use, eventually resulting in lamp failure.