Search results
Results from the WOW.Com Content Network
Split pins: Withdrawn: DIN EN ISO 1234: ISO 1234: DIN 95: Slotted Raised Countersunk (Oval) Head Wood Screws ... Round Nut with Set Pin Holes Inside; ISO Metric Fine ...
A split pin, also known as a cotter pin, or cotter key in the US, [1] is a metal fastener with two tines that are bent during installation, similar to a staple or rivet. Typically made of thick wire with a half-circular cross section, split pins come in multiple sizes and types.
A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other. Spring pins have a body diameter which is larger than the diameter of the hole they are intended for, and a chamfer on either one or both ends to facilitate starting the pin into the hole.
A brass fastener, butterfly clips, brad, paper fastener or split pin is a stationery item used for securing multiple sheets of paper together. A patent of the fastener was issued in 1866 to George W McGill. [ 1 ]
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
In the case of stored-value type cards, the association with a particular customer is only made if the prepaid card is reloadable. Card numbers are allocated in accordance with ISO/IEC 7812. The card number is typically embossed on the front of a payment card, and is encoded on the magnetic stripe and chip, but may also be imprinted on the back ...
Cotter pin may refer to: In U.S. usage: Split pin, a metal fastener with two tines that are bent during installation used to fasten metal together, like with a staple or rivet; Hairpin cotter pin, more commonly known as an "R-clip" Circle cotter, a ring-shaped cotter pin; In British usage:
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.