Search results
Results from the WOW.Com Content Network
The (TCP) and the (UDP) only need one for , bidirectional traffic. They usually use port numbers that match the services of the corresponding TCP or UDP implementation, if they exist. The Internet Assigned Numbers Authority (IANA) is responsible for maintaining the official assignments of port numbers for specific uses, [ 1 ] However, many ...
The TCP checksum is a weak check by modern standards and is normally paired with a CRC integrity check at layer 2, below both TCP and IP, such as is used in PPP or the Ethernet frame. However, introduction of errors in packets between CRC-protected hops is common and the 16-bit TCP checksum catches most of these.
Session-layer functionality is also realized with the port numbering of the TCP and UDP protocols, which are included in the transport layer of the TCP/IP suite. Functions of the presentation layer are realized in the TCP/IP applications with the MIME standard in data exchange.
IP was the connectionless datagram service in the original Transmission Control Program introduced by Vint Cerf and Bob Kahn in 1974, which was complemented by a connection-oriented service that became the basis for the Transmission Control Protocol (TCP). The Internet protocol suite is therefore often referred to as TCP/IP.
Because both TCP and UDP run over the same network, in the mid-2000s a few businesses found that an increase in UDP traffic from these real-time applications slightly hindered the performance of applications using TCP such as point of sale, accounting, and database systems (when TCP detects packet loss, it will throttle back its data rate usage).
IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol: RFC 1190, RFC 1819: 0x06 6 TCP Transmission Control Protocol: RFC 793: 0x07 7 CBT Core-based trees: RFC 2189: 0x08 8 EGP Exterior Gateway Protocol: RFC 888: 0x09 9 IGP Interior gateway protocol (any private interior gateway, for example Cisco's IGRP) 0x0A 10 BBN-RCC-MON
The Internet is a packet-switched network, and most of the protocols in this list are designed for its protocol stack, the IP protocol suite. They use one of two transport layer protocols: the Transmission Control Protocol (TCP) or the User Datagram Protocol (UDP).
TCP and UDP, have a checksum that covers all the data they carry, as well as the TCP or UDP header, plus a pseudo-header that contains the source and destination IP addresses of the packet carrying the TCP or UDP header. For an originating NAT to pass TCP or UDP successfully, it must recompute the TCP or UDP header checksum based on the ...