Search results
Results from the WOW.Com Content Network
The TCP checksum is a weak check by modern standards and is normally paired with a CRC integrity check at layer 2, below both TCP and IP, such as is used in PPP or the Ethernet frame. However, introduction of errors in packets between CRC-protected hops is common and the 16-bit TCP checksum catches most of these.
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for duplex, bidirectional traffic. They usually use port numbers that match the services of the corresponding TCP or UDP implementation, if they exist.
Session-layer functionality is also realized with the port numbering of the TCP and UDP protocols, which are included in the transport layer of the TCP/IP suite. Functions of the presentation layer are realized in the TCP/IP applications with the MIME standard in data exchange.
The Internet is a packet-switched network, and most of the protocols in this list are designed for its protocol stack, the IP protocol suite. They use one of two transport layer protocols: the Transmission Control Protocol (TCP) or the User Datagram Protocol (UDP).
Because both TCP and UDP run over the same network, in the mid-2000s a few businesses found that an increase in UDP traffic from these real-time applications slightly hindered the performance of applications using TCP such as point of sale, accounting, and database systems (when TCP detects packet loss, it will throttle back its data rate usage).
IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol: RFC 1190, RFC 1819: 0x06 6 TCP Transmission Control Protocol: RFC 793: 0x07 7 CBT Core-based trees: RFC 2189: 0x08 8 EGP Exterior Gateway Protocol: RFC 888: 0x09 9 IGP Interior gateway protocol (any private interior gateway, for example Cisco's IGRP) 0x0A 10 BBN-RCC-MON
IP was the connectionless datagram service in the original Transmission Control Program introduced by Vint Cerf and Bob Kahn in 1974, which was complemented by a connection-oriented service that became the basis for the Transmission Control Protocol (TCP). The Internet protocol suite is therefore often referred to as TCP/IP.
protocol: A transport protocol, e.g., TCP, UDP, raw IP. This means that (local or remote) endpoints with TCP port 53 and UDP port 53 are distinct sockets, while IP does not have ports. A socket that has been connected to another socket, e.g., during the establishment of a TCP connection, also has a remote socket address.