enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Blocking (construction) - Wikipedia

   en.wikipedia.org/wiki/Blocking_(construction)

   Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.

3. Dwang - Wikipedia

   en.wikipedia.org/wiki/Dwang

   In construction, a dwang (Scotland and New Zealand), [1] [2] [3] nogging piece, nogging, noggin or nog (England and Australia; all derived from brick nog), [4] [5] or blocking (North America), is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.

4. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

5. What's The Real Difference Between A Cupboard And A Cabinet ...

   www.aol.com/whats-real-difference-between...

   "Cabinets are made in certain sizes to fit a space, often going to the ceiling with moldings for a built-in look," she says, noting that cabinets are often found in functional spaces like kitchens ...

6. Wall stud - Wikipedia

   en.wikipedia.org/wiki/Wall_stud

   Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.

7. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame. It is common to place some sort of elastic material in the groove between the edge of the panel and the frame before assembly.