Search results
Results from the WOW.Com Content Network
However, its units are traditionally referred to as g, because of the relation between load factor and apparent acceleration of gravity felt on board the aircraft. A load factor of one, or 1 g, represents conditions in straight and level flight, where the lift is equal to the weight.
The FLTCON Namelist describes the flight conditions for the case. A maximum of 400 Mach-altitude combinations can be run at once, with up to 20 angles of attack for each combination. The user can specify whether the Mach number and altitude varies together, the Mach number varies at a constant altitude, or the altitude varies at a constant Mach ...
Geopotential height differs from geometric height (as given by a tape measure) because Earth's gravity is not constant, varying markedly with altitude and latitude; thus, a 1-m geopotential height difference implies a different vertical distance in physical space: "the unit-mass must be lifted higher at the equator than at the pole, if the same ...
In these equations, g 0, M and R * are each single-valued constants, while ρ, L, T and h are multi-valued constants in accordance with the table below. The values used for M, g 0 and R * are in accordance with the U.S. Standard Atmosphere, 1976, and that the value for R * in particular does not agree with standard values for this constant. [2]
Center-of-Gravity Limits Center of gravity (CG) limits are specified longitudinal (forward and aft) and/or lateral (left and right) limits within which the aircraft's center of gravity must be located during flight. The CG limits are indicated in the airplane flight manual. The area between the limits is called the CG range of the aircraft.
Lifting line theory supposes wings that are long and thin with negligible fuselage, akin to a thin bar (the eponymous "lifting line") of span 2s driven through the fluid. . From the Kutta–Joukowski theorem, the lift L(y) on a 2-dimensional segment of the wing at distance y from the fuselage is proportional to the circulation Γ(y) about the bar a
Compressor performance changes, day to day, with changes in the ambient pressure and temperature. Woolenweber [11] shows the change in performance of a turbocharger compressor when the inlet temperature varies between 70 and 100 deg F. In the case of aircraft compressors, inlet pressure and temperature also change with altitude and airspeed.
These points form a line, and y = x is said to be the equation for this line. In general, linear equations involving x and y specify lines, quadratic equations specify conic sections, and more complicated equations describe more complicated figures. [17] Usually, a single equation corresponds to a curve on the plane.