Search results
Results from the WOW.Com Content Network
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
Three RCA connectors - yellow for composite video, and white and red for stereo audio RCA connector: Widely used in consumer electronics for audio and video. A single connector must be used for each signal. SCART: Consumer electronics, mostly in Europe. Carries analog stereo sound, along with composite video and/or RGB video.
Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...
In some instances USB through version 2 on motherboards – 2.54 mm pitch, 10 pins, 2×5 (2 rows of 5 pins) [9] For all of the above connectors, the computer manufacturer typically attaches a female IDC connector onto one end of a ribbon cable, and later slides that connector onto a matching male box header or pin header on the computer ...
The connector is also used in other telecommunications connections, including ISDN and T1. Where building network and telephone wiring is pre-installed, the center (blue) pair is often used to carry telephony signals. While this allows an RJ11 plug to connect, it may damage the modular jack; an approved converter prevents damage.
The compact size lets a low-profile card support two high resolution displays, and a full-height card (with two DMS-59 connectors) up to four high resolution displays. The DMS-59 connector was used by e.g. AMD , Nvidia and Matrox for video cards sold in some Lenovo ThinkStation models, Viglen Genies and Omninos, Dell, HP and Compaq computers.
IEC 61076-2-109 M12 connectors with screw-locking for data transmission frequencies up to 500 MHz: M12 X and H-coding; IEC 61076-2-111 M12 power connectors with screw-locking: M12 E, F, K, L, M, S, T-coding; IEC 61076-2-113 M12 connectors with screw-locking, power and signal contacts for data transmission frequencies up to 100 MHz: M12 Y-coding [6]