Search results
Results from the WOW.Com Content Network
Input/output Buffer Information Specification (IBIS) is a specification of a method for integrated circuit vendors to provide information about the input/output buffers of their product to their prospective customers without revealing the intellectual property of their implementation and without requiring proprietary encryption keys. [1]
Bufferbloat is the undesirable latency that comes from a router or other network equipment buffering too many data packets.Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput.
Optical burst switching (OBS) is an optical networking technique that allows dynamic sub-wavelength switching of data. OBS is viewed as a compromise between the yet unfeasible full optical packet switching (OPS) and the mostly static optical circuit switching (OCS).
Next to the obvious choice of dropping all excess packets, academic literature typically presents three solutions: buffering, deflection routing or wavelength conversion. Optical buffering uses fiber delay lines (FDLs) to delay the light, and is regarded as the most effective, but comes with the additional cost of the FDLs.
CompuServe developed its own packet switching network, implemented on DEC PDP-11 minicomputers acting as network nodes that were installed throughout the US (and later, in other countries) and interconnected. Over time, the CompuServe network evolved into a complicated multi-tiered network incorporating ATM, Frame Relay, IP and X.25 technologies.
Note that 3 shows a swap chain with three buffers; the original definition of triple buffering would throw away frame C as soon as frame D finished, and start drawing frame E into buffer 1 with no delay. Set 4 shows what happens when a frame (B, in this case) takes longer than normal to draw. In this case, a frame update is missed.
In computer science, a data buffer (or just buffer) is a region of memory used to store data temporarily while it is being moved from one place to another. Typically, the data is stored in a buffer as it is retrieved from an input device (such as a microphone) or just before it is sent to an output device (such as speakers); however, a buffer may be used when data is moved between processes ...
When a station wishes to pause the other end of a link, it sends a pause frame to either the unique 48-bit destination address of this link or to the 48-bit reserved multicast address of 01-80-C2-00-00-01. [2]: Annex 31B.3.3 The use of a well-known address makes it unnecessary for a station to discover and store the address of the station at ...