Search results
Results from the WOW.Com Content Network
This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.
If the first digit on a lamp says 8, then the CRI of that lamp will be approximately 85. The last two digits indicate the color temperature of the lamp in kelvins (K). For example, if the last two digits on a lamp say 41 , that lamp's color temperature will be 4100 K, which is a common tri-phosphor cool white fluorescent lamp.
Leading edge modulation (top plot) uses a reverse sawtooth wave to generate the PWM. The PWM's leading edge is held at the leading edge of the window and the trailing edge is modulated. Trailing edge modulation (middle plot) uses a normal sawtooth wave to generate the PWM. The PWM's trailing edge is fixed and the leading edge is modulated.
A rising edge (or positive edge) is the low-to-high transition. [1] A falling edge (or negative edge) is the high-to-low transition. [1] In the case of a pulse, which consists of two edges: The leading edge (or front edge) is the first edge of the pulse. The trailing edge (or back edge) is the second edge of the pulse.
The dimmer switch used in conjunction with a dimmable CFL must be matched to its power consumption range; [58] many dimmers installed for use with incandescent bulbs do not function acceptably below 40 W, whereas CFL applications commonly draw power in the range 7–20 W. Dimmable CFLs have been marketed before suitable dimmers are available.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
The contacts of a 3-way bulb Circuit diagram of a 3-way bulb. A 3-way incandescent bulb has two filaments designed to produce different amounts of light. The two filaments can be activated separately or together, giving three different amounts of light. One common 3-way incandescent bulb is the 50/100/150 W.
The first VFD was the single indication DM160 by Philips in 1959. [5] The first multi-segment VFD was a 1967 Japanese single-digit, seven-segment device made by Ise Electronics Corporation. [6] The displays became common on calculators and other consumer electronics devices. [7] In the late 1980s hundreds of millions of units were made yearly. [8]