Search results
Results from the WOW.Com Content Network
A defect detector would sound like this: (This was the read out of CSX train Q452-05 by the Campville Defect Detector on April 6, 2019. The defect detector is located at Campville, Florida, on the CSX Wildwood Subdivision.) CSX EQUIPMENT DEFECT DETECTOR. MILEPOST 7-0-0-POINT-1. NO DEFECTS. NO DEFECTS. TOTAL AXLES 7-3-8. TRAIN LENGTH 1-3-7-6-4 ...
The primary purpose of leak detection systems (LDS) is to help pipeline controllers to detect and localize leaks. LDS provide alarms and display other related data to the pipeline controllers to assist decision-making. Pipeline leak detection systems can also enhance productivity and system reliability thanks to reduced downtime and inspection ...
Any leak which, in the judgment of operating personnel at the scene, is of sufficient magnitude to justify scheduled repair. A Grade 3 leak is non-hazardous at the time of detection and can be reasonably expected to remain non-hazardous. Examples of a Grade 3 Leak are: Any reading of less than 80% LEL in small gas associated substructures.
A tracer-gas leak testing method is a nondestructive testing method that detects gas leaks.A variety of methods with different sensitivities exist. Tracer-gas leak testing is used in the petrochemical industry, the automotive industry, the construction industry [1] and in the manufacture of semiconductors, among other uses.
A leak will give a similar result to permanent set, but will be detectable by holding the volume in the pressurised vessel by closing the inlet valve for a period before depressurising, as the pressure will drop steadily during this period if there is a leak. In most cases a permanent set that exceeds the specified maximum will indicate failure.
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
Tank leak detection is implemented to alert the operator to a suspected release from any part of a storage tank system, what enables to prevent from soil contamination and loss of product. In many countries regulated UST are required to have an approved leak detection method so that leaks are discovered quickly and the release is stopped in time.
The vacuum chamber is connected to a vacuum pumping system and a leak detector. Once the vacuum has reached the mass spectrometer operating pressure, any helium leakage will be measured. This test method applies to a lot of components that will operate under pressure: airbag canisters, evaporators, condensers, high-voltage SF 6 filled switchgear.