enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ISO 668 - Wikipedia

   en.wikipedia.org/wiki/ISO_668

   The ISO 668 standard firstly classifies containers by their length in whole feet for their 'common names', despite all measurement units used being either metric (SI) or officially based on the metric system. The exact standard length of '30-foot' and shorter containers is actually slightly shorter than their nominal length, to accommodate for ...

3. Drum (container) - Wikipedia

   en.wikipedia.org/wiki/Drum_(container)

   Standard drums have inside dimensions of 572 millimetres (22.5 in) diameter and 851 millimetres (33.5 in) height. These dimensions yield a volume of about 218.7 litres (57.8 US gal; 48.1 imp gal), but they are commonly filled to about 200 litres. Red steel drum on the frozen Lake Jyväsjärvi in Jyväskylä, Finland

4. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   In most of the world, sheet metal thickness is consistently specified in millimeters. In the U.S., the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its gauge. The larger the gauge number, the thinner the metal. Commonly used steel sheet metal ranges from 30 gauge to about 7 gauge.

5. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

6. Hollow structural section - Wikipedia

   en.wikipedia.org/wiki/Hollow_structural_section

   In the recent past, HSS was commonly available in mild steel, such as A500 grade B. Today, HSS is commonly available in mild steel, A500 grade C. Other steel grades available for HSS are A847 (weathering steel), A1065 (large sections up to 50 inch sq made with SAW process), and recently approved A1085 (higher strength, tighter tolerances than ...

7. List of ISO standards 1–1999 - Wikipedia

   en.wikipedia.org/wiki/List_of_ISO_standards_1–1999

   ISO 1106-2:1985 Part 2: Fusion welded butt joints in steel plates thicker than 50 mm and up to and including 200 mm in thickness [Withdrawn: replaced with ISO 17636] ISO 1106-3:1984 Part 3: Fusion welded circumferential joints in steel pipes of up to 50 mm wall thickness [Withdrawn: replaced with ISO 17636]