Search results
Results from the WOW.Com Content Network
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
The signal format that the router transports can be anything from analogue composite video using PAL and NTSC. Also multi-format routers can route more than one Digital video signal format, serial digital interface (SDI), HD-SDI, component video. Some routers have the ability to internally convert digital to analog and analog to digital.
Serial digital interface (SDI) and HD-SDI. CoaXPress; 75 Ω for video signal (SDI and CoaXPress) on, for example, RG59 and RG6. 50 Ω for data link, like Ethernet on RG58. 93 Ω on RG62. 50 Ω (white/bottom row) and 75 Ω C connectors (red/top row) C connector (Concelman connector) General Radio 874 connectors GR connector (General Radio connector)
S-Video (1 Mini-DIN) SDI - Broadcast grade digital interface over BNC cables; VGA connector A type of D-sub connector standard on most video cards; Mini-VGA Found on some laptop computers; 5 BNC Connectors can also be used to carry the VGA signal as R, G, B, HSync, VSync; Digital Visual Interface (DVI) A hybrid analog/digital connector commonly ...
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
If an SDTI stream is viewed using a standard SDI device, then the raw data can be seen as a small strip along the left-hand side (usually in purple). The DVCAM SDTI has video data at the top, control data in the middle (Timecode, etc.) and audio at the bottom just like it is organised on the tape.
A Transport Stream, and thereby ASI when over coax, can carry one or multiple SD, HD or audio programs that are already compressed, as opposed to an uncompressed SD-SDI (270 Mbit/s) or HD-SDI (1.485 Gbit/s). An ASI signal can be at varying transmission speeds and is completely dependent on the user's engineering requirements.
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.