enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Industrial and multiphase power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/Industrial_and_multiphase...

   The type 15 plug and socket has 3 round pins of 4 mm diameter, plus 2 flat pins (for L2 and L3). It is designed for three phase applications and is rated at 10 A, 250 V/440 V. The socket will also accept types 11 and 12 plugs, and the Europlug. The type 25 plug and socket has 3 rectangular pins, 4 mm x 5 mm, plus 2 flat pins (for L2 and L3).

3. Three-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Three-phase_electric_power

   This setup produces three different voltages: If the voltage between the center tap (neutral) and each of the top and bottom taps (phase and anti-phase) is 120 V (100%), the voltage across the phase and anti-phase lines is 240 V (200%), and the neutral to "high leg" voltage is ≈ 208 V (173%).

4. High-leg delta - Wikipedia

   en.wikipedia.org/wiki/High-leg_delta

   So if A–B, B–C and C–A are all 240 volts, then A–N and C–N will both be 120 volts, but B–N will be 208 volts. Other types of three-phase supplies are wye connections, ungrounded delta connections, or corner-grounded delta [2] (ghost leg configuration) connections. These connections do not supply split single-phase power, and do not ...

5. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   All NEMA 14 devices offer two hots, a neutral, and a ground, allowing for both 120 and 240 V when supplied by split-phase power, or 120 and 208 V if the supply is three-phase. The 14-30 has a rating of 30 A, and an L-shaped neutral blade.

6. Mains electricity by country - Wikipedia

   en.wikipedia.org/wiki/Mains_electricity_by_country

   120/208 V 277/480 V 120/240 V 240/208/120 V 240 V 480 V 60 Hz [22] NEMA 5-20R outlets, which are similar to type B but have a T-shaped neutral slot, are sometimes used for higher current 120 V commercial equipments (up to 20 A). On the other hand, NEMA 10-50P outlets are sometimes used for 208 V and 240 V industrial equipments (up to 50 A).

7. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   This allows one to choose single-phase AC power at either 110–120 volts between phase and neutral or 220–240 volts between phase and phase. Since these two modes do not need three phases there is also a dark yellow-orange four-pin connector available designed for a single-phase 110–120 or 220–240 volt load.